관리-도구

편집 파일: gpmc-omap.h

/* SPDX-License-Identifier: GPL-2.0-only */ /* * OMAP GPMC Platform data * * Copyright (C) 2014 Texas Instruments, Inc. - https://www.ti.com * Roger Quadros <rogerq@ti.com> */ #ifndef _GPMC_OMAP_H_ #define _GPMC_OMAP_H_ /* Maximum Number of Chip Selects */ #define GPMC_CS_NUM 8 /* bool type time settings */ struct gpmc_bool_timings { bool cycle2cyclediffcsen; bool cycle2cyclesamecsen; bool we_extra_delay; bool oe_extra_delay; bool adv_extra_delay; bool cs_extra_delay; bool time_para_granularity; }; /* * Note that all values in this struct are in nanoseconds except sync_clk * (which is in picoseconds), while the register values are in gpmc_fck cycles. */ struct gpmc_timings { /* Minimum clock period for synchronous mode (in picoseconds) */ u32 sync_clk; /* Chip-select signal timings corresponding to GPMC_CS_CONFIG2 */ u32 cs_on; /* Assertion time */ u32 cs_rd_off; /* Read deassertion time */ u32 cs_wr_off; /* Write deassertion time */ /* ADV signal timings corresponding to GPMC_CONFIG3 */ u32 adv_on; /* Assertion time */ u32 adv_rd_off; /* Read deassertion time */ u32 adv_wr_off; /* Write deassertion time */ u32 adv_aad_mux_on; /* ADV assertion time for AAD */ u32 adv_aad_mux_rd_off; /* ADV read deassertion time for AAD */ u32 adv_aad_mux_wr_off; /* ADV write deassertion time for AAD */ /* WE signals timings corresponding to GPMC_CONFIG4 */ u32 we_on; /* WE assertion time */ u32 we_off; /* WE deassertion time */ /* OE signals timings corresponding to GPMC_CONFIG4 */ u32 oe_on; /* OE assertion time */ u32 oe_off; /* OE deassertion time */ u32 oe_aad_mux_on; /* OE assertion time for AAD */ u32 oe_aad_mux_off; /* OE deassertion time for AAD */ /* Access time and cycle time timings corresponding to GPMC_CONFIG5 */ u32 page_burst_access; /* Multiple access word delay */ u32 access; /* Start-cycle to first data valid delay */ u32 rd_cycle; /* Total read cycle time */ u32 wr_cycle; /* Total write cycle time */ u32 bus_turnaround; u32 cycle2cycle_delay; u32 wait_monitoring; u32 clk_activation; /* The following are only on OMAP3430 */ u32 wr_access; /* WRACCESSTIME */ u32 wr_data_mux_bus; /* WRDATAONADMUXBUS */ struct gpmc_bool_timings bool_timings; }; /* Device timings in picoseconds */ struct gpmc_device_timings { u32 t_ceasu; /* address setup to CS valid */ u32 t_avdasu; /* address setup to ADV valid */ /* XXX: try to combine t_avdp_r & t_avdp_w. Issue is * of tusb using these timings even for sync whilst * ideally for adv_rd/(wr)_off it should have considered * t_avdh instead. This indirectly necessitates r/w * variations of t_avdp as it is possible to have one * sync & other async */ u32 t_avdp_r; /* ADV low time (what about t_cer ?) */ u32 t_avdp_w; u32 t_aavdh; /* address hold time */ u32 t_oeasu; /* address setup to OE valid */ u32 t_aa; /* access time from ADV assertion */ u32 t_iaa; /* initial access time */ u32 t_oe; /* access time from OE assertion */ u32 t_ce; /* access time from CS asertion */ u32 t_rd_cycle; /* read cycle time */ u32 t_cez_r; /* read CS deassertion to high Z */ u32 t_cez_w; /* write CS deassertion to high Z */ u32 t_oez; /* OE deassertion to high Z */ u32 t_weasu; /* address setup to WE valid */ u32 t_wpl; /* write assertion time */ u32 t_wph; /* write deassertion time */ u32 t_wr_cycle; /* write cycle time */ u32 clk; u32 t_bacc; /* burst access valid clock to output delay */ u32 t_ces; /* CS setup time to clk */ u32 t_avds; /* ADV setup time to clk */ u32 t_avdh; /* ADV hold time from clk */ u32 t_ach; /* address hold time from clk */ u32 t_rdyo; /* clk to ready valid */ u32 t_ce_rdyz; /* XXX: description ?, or use t_cez instead */ u32 t_ce_avd; /* CS on to ADV on delay */ /* XXX: check the possibility of combining * cyc_aavhd_oe & cyc_aavdh_we */ u8 cyc_aavdh_oe;/* read address hold time in cycles */ u8 cyc_aavdh_we;/* write address hold time in cycles */ u8 cyc_oe; /* access time from OE assertion in cycles */ u8 cyc_wpl; /* write deassertion time in cycles */ u32 cyc_iaa; /* initial access time in cycles */ /* extra delays */ bool ce_xdelay; bool avd_xdelay; bool oe_xdelay; bool we_xdelay; }; #define GPMC_BURST_4 4 /* 4 word burst */ #define GPMC_BURST_8 8 /* 8 word burst */ #define GPMC_BURST_16 16 /* 16 word burst */ #define GPMC_DEVWIDTH_8BIT 1 /* 8-bit device width */ #define GPMC_DEVWIDTH_16BIT 2 /* 16-bit device width */ #define GPMC_MUX_AAD 1 /* Addr-Addr-Data multiplex */ #define GPMC_MUX_AD 2 /* Addr-Data multiplex */ struct gpmc_settings { bool burst_wrap; /* enables wrap bursting */ bool burst_read; /* enables read page/burst mode */ bool burst_write; /* enables write page/burst mode */ bool device_nand; /* device is NAND */ bool sync_read; /* enables synchronous reads */ bool sync_write; /* enables synchronous writes */ bool wait_on_read; /* monitor wait on reads */ bool wait_on_write; /* monitor wait on writes */ u32 burst_len; /* page/burst length */ u32 device_width; /* device bus width (8 or 16 bit) */ u32 mux_add_data; /* multiplex address & data */ u32 wait_pin; /* wait-pin to be used */ }; /* Data for each chip select */ struct gpmc_omap_cs_data { bool valid; /* data is valid */ bool is_nand; /* device within this CS is NAND */ struct gpmc_settings *settings; struct gpmc_device_timings *device_timings; struct gpmc_timings *gpmc_timings; struct platform_device *pdev; /* device within this CS region */ unsigned int pdata_size; }; struct gpmc_omap_platform_data { struct gpmc_omap_cs_data cs[GPMC_CS_NUM]; }; #endif /* _GPMC_OMAP_H */