관리-도구

편집 파일: iosf_mbi.h

/* SPDX-License-Identifier: GPL-2.0 */ /* * Intel OnChip System Fabric MailBox access support */ #ifndef IOSF_MBI_SYMS_H #define IOSF_MBI_SYMS_H #include <linux/notifier.h> #define MBI_MCR_OFFSET 0xD0 #define MBI_MDR_OFFSET 0xD4 #define MBI_MCRX_OFFSET 0xD8 #define MBI_RD_MASK 0xFEFFFFFF #define MBI_WR_MASK 0X01000000 #define MBI_MASK_HI 0xFFFFFF00 #define MBI_MASK_LO 0x000000FF #define MBI_ENABLE 0xF0 /* IOSF SB read/write opcodes */ #define MBI_MMIO_READ 0x00 #define MBI_MMIO_WRITE 0x01 #define MBI_CFG_READ 0x04 #define MBI_CFG_WRITE 0x05 #define MBI_CR_READ 0x06 #define MBI_CR_WRITE 0x07 #define MBI_REG_READ 0x10 #define MBI_REG_WRITE 0x11 #define MBI_ESRAM_READ 0x12 #define MBI_ESRAM_WRITE 0x13 /* Baytrail available units */ #define BT_MBI_UNIT_AUNIT 0x00 #define BT_MBI_UNIT_SMC 0x01 #define BT_MBI_UNIT_CPU 0x02 #define BT_MBI_UNIT_BUNIT 0x03 #define BT_MBI_UNIT_PMC 0x04 #define BT_MBI_UNIT_GFX 0x06 #define BT_MBI_UNIT_SMI 0x0C #define BT_MBI_UNIT_CCK 0x14 #define BT_MBI_UNIT_USB 0x43 #define BT_MBI_UNIT_SATA 0xA3 #define BT_MBI_UNIT_PCIE 0xA6 /* Quark available units */ #define QRK_MBI_UNIT_HBA 0x00 #define QRK_MBI_UNIT_HB 0x03 #define QRK_MBI_UNIT_RMU 0x04 #define QRK_MBI_UNIT_MM 0x05 #define QRK_MBI_UNIT_SOC 0x31 /* Action values for the pmic_bus_access_notifier functions */ #define MBI_PMIC_BUS_ACCESS_BEGIN 1 #define MBI_PMIC_BUS_ACCESS_END 2 #if IS_ENABLED(CONFIG_IOSF_MBI) bool iosf_mbi_available(void); /** * iosf_mbi_read() - MailBox Interface read command * @port: port indicating subunit being accessed * @opcode: port specific read or write opcode * @offset: register address offset * @mdr: register data to be read * * Locking is handled by spinlock - cannot sleep. * Return: Nonzero on error */ int iosf_mbi_read(u8 port, u8 opcode, u32 offset, u32 *mdr); /** * iosf_mbi_write() - MailBox unmasked write command * @port: port indicating subunit being accessed * @opcode: port specific read or write opcode * @offset: register address offset * @mdr: register data to be written * * Locking is handled by spinlock - cannot sleep. * Return: Nonzero on error */ int iosf_mbi_write(u8 port, u8 opcode, u32 offset, u32 mdr); /** * iosf_mbi_modify() - MailBox masked write command * @port: port indicating subunit being accessed * @opcode: port specific read or write opcode * @offset: register address offset * @mdr: register data being modified * @mask: mask indicating bits in mdr to be modified * * Locking is handled by spinlock - cannot sleep. * Return: Nonzero on error */ int iosf_mbi_modify(u8 port, u8 opcode, u32 offset, u32 mdr, u32 mask); /** * iosf_mbi_punit_acquire() - Acquire access to the P-Unit * * One some systems the P-Unit accesses the PMIC to change various voltages * through the same bus as other kernel drivers use for e.g. battery monitoring. * * If a driver sends requests to the P-Unit which require the P-Unit to access * the PMIC bus while another driver is also accessing the PMIC bus various bad * things happen. * * Call this function before sending requests to the P-Unit which may make it * access the PMIC, be it through iosf_mbi* functions or through other means. * This function will block all kernel access to the PMIC I2C bus, so that the * P-Unit can safely access the PMIC over the shared I2C bus. * * Note on these systems the i2c-bus driver will request a sempahore from the * P-Unit for exclusive access to the PMIC bus when i2c drivers are accessing * it, but this does not appear to be sufficient, we still need to avoid making * certain P-Unit requests during the access window to avoid problems. * * This function locks a mutex, as such it may sleep. */ void iosf_mbi_punit_acquire(void); /** * iosf_mbi_punit_release() - Release access to the P-Unit */ void iosf_mbi_punit_release(void); /** * iosf_mbi_block_punit_i2c_access() - Block P-Unit accesses to the PMIC bus * * Call this function to block P-Unit access to the PMIC I2C bus, so that the * kernel can safely access the PMIC over the shared I2C bus. * * This function acquires the P-Unit bus semaphore and notifies * pmic_bus_access_notifier listeners that they may no longer access the * P-Unit in a way which may cause it to access the shared I2C bus. * * Note this function may be called multiple times and the bus will not * be released until iosf_mbi_unblock_punit_i2c_access() has been called the * same amount of times. * * Return: Nonzero on error */ int iosf_mbi_block_punit_i2c_access(void); /* * iosf_mbi_unblock_punit_i2c_access() - Release PMIC I2C bus block * * Release i2c access block gotten through iosf_mbi_block_punit_i2c_access(). */ void iosf_mbi_unblock_punit_i2c_access(void); /** * iosf_mbi_register_pmic_bus_access_notifier - Register PMIC bus notifier * * This function can be used by drivers which may need to acquire P-Unit * managed resources from interrupt context, where iosf_mbi_punit_acquire() * can not be used. * * This function allows a driver to register a notifier to get notified (in a * process context) before other drivers start accessing the PMIC bus. * * This allows the driver to acquire any resources, which it may need during * the window the other driver is accessing the PMIC, before hand. * * @nb: notifier_block to register */ int iosf_mbi_register_pmic_bus_access_notifier(struct notifier_block *nb); /** * iosf_mbi_register_pmic_bus_access_notifier - Unregister PMIC bus notifier * * @nb: notifier_block to unregister */ int iosf_mbi_unregister_pmic_bus_access_notifier(struct notifier_block *nb); /** * iosf_mbi_unregister_pmic_bus_access_notifier_unlocked - Unregister PMIC bus * notifier, unlocked * * Like iosf_mbi_unregister_pmic_bus_access_notifier(), but for use when the * caller has already called iosf_mbi_punit_acquire() itself. * * @nb: notifier_block to unregister */ int iosf_mbi_unregister_pmic_bus_access_notifier_unlocked( struct notifier_block *nb); /** * iosf_mbi_assert_punit_acquired - Assert that the P-Unit has been acquired. */ void iosf_mbi_assert_punit_acquired(void); #else /* CONFIG_IOSF_MBI is not enabled */ static inline bool iosf_mbi_available(void) { return false; } static inline int iosf_mbi_read(u8 port, u8 opcode, u32 offset, u32 *mdr) { WARN(1, "IOSF_MBI driver not available"); return -EPERM; } static inline int iosf_mbi_write(u8 port, u8 opcode, u32 offset, u32 mdr) { WARN(1, "IOSF_MBI driver not available"); return -EPERM; } static inline int iosf_mbi_modify(u8 port, u8 opcode, u32 offset, u32 mdr, u32 mask) { WARN(1, "IOSF_MBI driver not available"); return -EPERM; } static inline void iosf_mbi_punit_acquire(void) {} static inline void iosf_mbi_punit_release(void) {} static inline int iosf_mbi_register_pmic_bus_access_notifier(struct notifier_block *nb) { return 0; } static inline int iosf_mbi_unregister_pmic_bus_access_notifier(struct notifier_block *nb) { return 0; } static inline int iosf_mbi_unregister_pmic_bus_access_notifier_unlocked(struct notifier_block *nb) { return 0; } static inline int iosf_mbi_call_pmic_bus_access_notifier_chain(unsigned long val, void *v) { return 0; } static inline void iosf_mbi_assert_punit_acquired(void) {} #endif /* CONFIG_IOSF_MBI */ #endif /* IOSF_MBI_SYMS_H */